Search results for " Coating."
showing 10 items of 2558 documents
In Vitro Evaluation of Enteric-Coated HPMC Capsules—Effect of Formulation Factors on Product Performance
2020
A comparative study on different enteric-coated hard capsules was performed. The influence of different formulation factors like choice of enteric polymer, triethyl citrate (TEC) concentration (plasticizer), talc concentrations (anti-tacking agent), and different coating process parameters on the sealing performance of the capsule and the disintegration time were investigated. Furthermore, the influence of different disintegration test methods (with disc vs. without disc and 50 mM U.S. Pharmacopoeia (USP) buffer pH 6.8 vs. biopredictive 15 mM phosphate buffer pH 6.5) was evaluated. All formulations showed sufficient but not equivalent acid resistance when tested. Polymer type was the main f…
Study of the electronic and atomic structure of thermally treated SrTiO3(110) surfaces
2003
The electronic structure of heated SrTiO3(110) surfaces was investigated with metastable impact electron spectroscopy and ultraviolet photoelectron spectroscopy (He(I). Scanning tunnelling microscopy and atomic force microscopy (AFM) were used to study the topology of the surface. The crystals were heated up to 1000 °C under reducing conditions in ultrahigh vacuum or under oxidizing conditions in synthetic air for 1 h, respectively. Under both conditions microfacetting of the surface is observed. The experimental results are compared with ab initio Hartree-Fock calculations, also presented here, carried out for both ideal and reconstructed SrTiO 3(110) surfaces. The results give direct evid…
Crystal structure of sinhalite MgAlBO4 under high pressure
2015
We report on high-pressure angle-dispersive X-ray diffraction data up to 27 GPa for natural MgAlBO4 sinhalite mineral and ab initio total energy calculations. The experimental bulk modulus of sinhalite is B-0 = 171(3) GPa with a first-pressure derivative of B-0' = 4.2(3). A comparison with other olivine-type compounds shows that the value for B0 is 27% larger than that of Mg2SiO4 forsterite and 29% smaller than that of Al2BeO4 chrysoberyl. These differences are interpreted, on the basis of our ab initio calculations, in terms of the relative incompressibility of Al-O bonds in AlO6 octahedra (with a calculated bulk modulus of 250(1) GPa) as compared to Mg-O bonds in MgO6 octahedra (with a ca…
Fast and blister-free irradiation conditions for cross-linking of PMMA induced by 2MeV protons
2013
For soft lithography, the conventional negative tone resists, such as SU-8, that are used to create the mold have a number of drawbacks. PMMA, which is normally used as a positive tone resist, can be used as a negative resist by using high-fluence irradiation conditions. In this report, we outline optimization of the irradiation conditions for PMMA thin films using 2MeV H^+ ions to exploit their ability to work as a negative tone resist at ion fluences above 1.0x10^1^5ionscm^-^2. The main aim was to induce cross-linking while maintaining the exposed regions free of blisters and maintaining short irradiation times. We found that by using a two-step process with a low-flux irradiation, follow…
Electronic structure of p-type ultraviolet-transparent conducting CuScO2 films
2008
Abstract We investigate the electronic structure of CuScO 2 thin films grown on sapphire and mica substrates by pulsed laser deposition. X-ray diffraction and microanalysis confirm that the films have the expected delafossite crystal structure and stoichiometric proportions. The electronic structure is investigated by means of X-ray and ultraviolet photoelectron spectroscopy. Electronic states in the range 0–1350 eV are identified, making reference to theoretical density-of-states calculations up to 80 eV. Photoelectron spectra near the Fermi energy confirm the p-character of the films. Optical absorption spectroscopy shows that the films are transparent up to 3.7 eV and exhibit an intense …
Ab Initio Studies of Triplet-State Properties for Organic Semiconductor Molecules
2012
Triplet–triplet annihilation (TTA) leads to a reduced efficiency of organic light-emitting diodes (OLEDs) at high current densities. Spacial confinement of the triplet excitons, which is mainly dependent on triplet energy differences, can reduce the TTA rate. Therefore, a deliberate choice of the organic semiconductor materials with particular attention to their triplet energies can help to considerably increase the device efficiency. Organic solid-state lasers are, on the other hand, efficiently quenched by singlet–triplet annihilation (STA), which is closely related to the triplet–triplet absorption of the organic semiconductors. To establish a useful set of parameters related to the proc…
Miscibility of cyanine dyes in two-dimensional aggregates
1995
Mixed aggregates of cyanine dyes at a charged lipid monolayer surface are studied by absorption spectroscopy, fluorescence microscopy and electron diffraction. We show that slight variations of the molecular structure can convert a system from being fully miscible to being immiscible, and also that the concentrations of dyes in the solution and in the crystal may deviate considerably. The different concentration in the solution and crystal was observed for a molecule where force field calculations indicated the existence of two isomers in solution and where probably only one fits into the lattice.
External pressure and composition effects on the atomic and electronic structure of SnWO4
2015
The atomic and electronic structure of tin tungstates, α-SnWO4, α-Sn1.03W0.99O4 and β-SnWO4 ,w as studied by the W L3-edge X-ray absorption spectroscopy and first-principles linear combination of atomic orbital (LCAO) calculations based on the hybrid exchange-correlation density functional (DFT)/ Hartree–Fock (HF) scheme. It was found that the crystal structure of both α-phases is built up of strongly distorted WO6 octahedra, whereas that of β-SnWO4 is composed of nearly regular WO4 tetrahedra. In addition, there are distorted SnO6 octahedra in both α- and β-phases. The metal–oxygen octahedra distortion is explained by the second-order Jahn–Teller effect. The influence of pressure on the st…
Protonation of the Biliverdin IXα Chromophore in the Red and Far-Red Photoactive States of a Bacteriophytochrome
2019
The tetrapyrrole chromophore biliverdin IXα (BV) in the bacteriophytochrome from Deinococcus radiodurans (DrBphP) is usually assumed to be fully protonated, but this assumption has not been systematically validated by experiments or extensive computations. Here, we use force field molecular dynamics simulations and quantum mechanics/molecular mechanics calculations with density functional theory and XMCQDPT2 methods to investigate the effect of the five most probable protonation forms of BV on structural stability, binding pocket interactions, and absorption spectra in the two photochromic states of DrBphP. While agreement with X-ray structural data and measured UV/vis spectra suggest that …
Ag11(SG)7 : A New Cluster Identified by Mass Spectrometry and Optical Spectroscopy
2014
We report a one-step and high yield synthesis of a red-luminescent silver cluster with the molecular formula, Ag11(SG)7 (SG: glutathionate) via reduction of silver ions by sodium borohydride in the presence of the tripeptide, glutathione (GSH). The as-prepared cluster shows prominent absorption features at 485 and 625 nm in its UV-vis absorption spectrum. Aging of the as-prepared cluster solution led to the disappearance of the 625 nm peak, followed by broadening of the 485 nm peak to give three maxima at ?487, 437, and 393 nm in its absorption spectrum. These peaks remain unchanged even after polyacrylamide gel electrophoresis (PAGE), where a single band was observed confirming high purity…