Search results for " Detectors"
showing 10 items of 2027 documents
Two-dimensional nuclear magnetic resonance spectroscopy with a microfluidic diamond quantum sensor
2019
Quantum sensors based on nitrogen-vacancy centers in diamond have emerged as a promising detection modality for nuclear magnetic resonance (NMR) spectroscopy owing to their micron-scale detection volume and non-inductive based detection. A remaining challenge is to realize sufficiently high spectral resolution and concentration sensitivity for multidimensional NMR analysis of picoliter sample volumes. Here, we address this challenge by spatially separating the polarization and detection phases of the experiment in a microfluidic platform. We realize a spectral resolution of 0.65 +/- 0.05 Hz, an order-of-magnitude improvement over previous diamond NMR studies. We use the platform to perform …
A Composite Phononic Crystal Design for Quasiparticle Lifetime Enhancement in Kinetic Inductance Detectors
2019
A nanoscale phononic crystal filter (reflector) is designed for a kinetic inductance detector where the reflection band is matched to the quasiparticle recombination phonons with the aim to increase quasiparticle lifetime in the superconducting resonator. The inductor is enclosed by a 1 um wide phononic crystal membrane section with two simple hole patterns that each contain a partial spectral gap for various high frequency phonon modes. The phononic crystal is narrow enough for low frequency thermal phonons to propagate unimpeded. With 3D phonon scattering simulations over a 40 dB attenuation in transmitted power is found for the crystal, which was previously estimated to give a lifetime e…
Superconductor-ferromagnet tunnel junction thermoelectric bolometer and calorimeter with a SQUID readout
2020
Superconductor-ferromagnet thermoelectric detector (SFTED) is a novel ultrasensitive radiation detector based on the giant thermoelectric effect in superconductor-ferromagnet tunnel junctions. This type of detector can be operated without the need of additional bias lines, and is predicted to provide a performance rivaling transition-edge sensors and kinetic inductance detectors. Here we report our numerical studies on the SFTED noise equivalent power, energy resolution and time constant, and the feasibility of a SQUID readout in both bolometric and calorimetric regimes, with the goal to provide practical design parameters for the detector fabrication and the readout circuitry implementatio…
Copper coated carbon fiber reinforced plastics for high and ultra high vacuum applications
2014
We have used copper-coated carbon fiber reinforced plastic (CuCFRP) for the construction of high and ultra-high vacuum recipients. The vacuum performance is found to be comparable to typical stainless steel used for this purpose. In test recipients we have reached pressures of 2E-8 mbar and measured a desorption rate of 1E-11 mbar*liter/s/cm^2; no degradation over time (2 years) has been found. Suitability for baking has been found to depend on the CFRP production process, presumably on the temperature of the autoclave curing. Together with other unique properties of CuCFRP such as low weight and being nearly non-magnetic, this makes it an ideal material for many high-end vacuum application…
Microcavity Light Emitting Diodes Based on GaN membranes Grown by Molecular Beam Epitaxy on Silicon
2003
Resonant-cavity InGaN/GaN quantum well light emitting diodes have been fabricated. Nitride layers were grown by molecular beam epitaxy on Si (111). We fabricated the structures using a combination of Si substrate etching, GaN etching and dielectric (Ta2O5/SiO2) mirror deposition. The electroluminescence spectra show that the emission within the distributed Bragg reflector stop band is enhanced in the membrane microcavity. The cavity modes are broadened by some cavity length non-uniformity that is introduced when the GaN is back etched to adjust the cavity length. This process does not need any transfer on an intermediate host substrate and is fully compatible with large area semiconductor p…
Near-band luminescence of CdZnTe detector crystals
2012
The near-band luminescence due to both neutral donor and neutral acceptor bound excitons (D0 Ex), (A0Ex) and its phonon replicas as well as luminescence of donor-acceptor pair (DAP) and deep energy level due to undefined defect state (A band) were studied in CZT detector crystals. The near-band luminescence correlation with detector characteristics was analyzed and the results could be applied for nondestructive detector material selection. It is obtained that some parameters such as a presence and intensity of A and DAP luminescence bands, the decay kinetics in A0Ex-1LO and DAP luminescence bands, are most important characteristics for detector material characterization.
CdTe Detectors
2014
Cadmium telluride (CdTe) compound semiconductors for x-ray detectors have experienced a rather rapid development in the last few years, due to their appealing performance. In this chapter we review the physical properties of semiconductor detectors for x-ray and γ ray spectroscopy. In particular, we focus on compound semiconductor detectors. We also review the principles of operation of both the semiconductor detectors and the electronic chains, with special emphasis on the digital techniques. CdTe detectors’ characteristics and performance enhancements are discussed in depth. Finally, we present some original results on CdTe detectors for medical applications.
Optical investigation of the OH− groups in the LiNbO3 doped by copper
2019
Doping ions and OH− groups absorption bands spatial profiles were investigated for the case of congruent LiNbO3 single crystal grown by Czochralski technique. Doping was performed after the crystal...
The Engineering of Hot Carbon Nanotubes with a Focused Electron Beam
2004
Single-wall and multiwall carbon nanotubes at high temperature are irradiated with the focused electron beam in an electron microscope. Nanotubes can be tailored with monolayer precision, and new morphologies of nanotubes are created. Atoms from layers of multiwall tubes can be removed and the tubes can be bent by a predefined angle. Bundles of single-wall tubes are transformed locally to multiwall tubes with coherent transition between the two modifications.
Positron lifetime measurements on neutron‐irradiated InP crystals
1996
Neutron‐irradiated InP single crystals have been investigated by positron‐lifetime measurements. The samples were irradiated with thermal neutrons at different fluences yielding concentrations for Sn‐transmuted atoms between 2×1015 and 2×1018 cm−3. The lifetime spectra have been analyzed into one exponential decay component. The mean lifetimes show a monotonous increase with the irradiation dose from 246 to 282 ps. The increase in the lifetime has been associated to a defect containing an Indium vacancy. Thermal annealing at 550 °C reduces the lifetime until values closed to those obtained for the as‐grown and conventionally doped InP crystals. navarrof@evalvx.ific.uv.es ; Jose.Ferrero@uv.es