Search results for "A-Si"

HF radar for wind waves measurements in the Malta-Sicily Channel

2018

Abstract The CALYPSO HF radar network is a permanent and fully operational observing system currently composed of four CODAR SeaSonde stations. The system is providing real-time hourly maps of sea surface currents and waves data in the Malta-Sicily Channel. The present work aims to compare significant wave height measurements by HF Radar to wave data from numerical models and satellite altimeter. This is the first time that this set of wave data are analysed since the four HF radars were installed between 2012 and 2015. Results suggest that CODAR HF Radar wave data are a reliable source of wave information even in the case of extreme events, providing an avenue to improve and complete the o…

A new approach to ticagrelor-based de-escalation of antiplatelet therapy after acute coronary syndrome. A rationale for a randomized, double-blind, p…

2021

The risk of ischemic events gradually decreases after acute coronary syndrome (ACS), reaching a stable level after 1 month, while the risk of bleeding remains steady during the whole period of dual antiplatelet treatment (DAPT). Several de-escalation strategies of antiplatelet treatment aiming to enhance safety of DAPT without depriving it of its efficacy have been evaluated so far. We hypothesized that reduction of the ticagrelor maintenance dose 1 month after ACS and its continuation until 12 months after ACS may improve adherence to antiplatelet treatment due to better tolerability compared with the standard dose of ticagrelor. Moreover, improved safety of treatment and preserved anti-is…

Plasmonic effects of ultra-thin Mo films on hydrogenated amorphous Si photovoltaic cells

2012

We report on the improvement of short circuit current (JSC), fill factor (FF), and open circuit resistance (ROC) in hydrogenated amorphous silicon (a-Si:H) photovoltaic cells with a p-type/intrinsic/n-type structure, achieved by the addition of an ultra-thin molybdenum film between the p-type film and the transparent conductive oxide/glass substrate. For suitable conditions, improvements of ≈10% in average internal quantum efficiency and up to 5%–10% under standard illumination in JSC, FF, and ROC are observed. These are attributed to the excitation of surface plasmon polariton modes of the a-Si:H/Mo interface.

Comparison between textured SnO2:F and Mo contacts with the p-type layer in p–i–n hydrogenate amorphous silicon solar cells by forward bias impedance…

2013

Abstract In this paper we compare the performance of the textured SnO2:F and Mo contacts with the p-type layer in p–i–n hydrogenate amorphous silicon (a-Si:H) solar cells. We use standard current–voltage (I–V) electrical characterization methods coupled with forward bias small signal impedance analysis. We show the efficacy of this technique to determine the effective carrier lifetime in photovoltaic cells. We show that such effective lifetimes are indeed directly connected to the respective dark diode saturation currents. We also find that the effective lifetime is constant with the temperature in the 0–70 °C range and it is significantly better for the solar cell with Mo diode contact. Th…

Instabilities Effects in Thin Film Solar Cells: Reversible Ageing, Performance Recovery and Improvement by Electrical Stresses

Adsorption of 3d Transition Elements on a TiO2(110) Surface.

2008

International audience; A first-principles study on the adsorption of 3d transition metal atoms on a stoichiometric TiO2(110) surface is reported. For all 3d elements except Cu, the most stable on-surface adsorption site is a site where the adatom binds to two twofold and one threefold surface oxygen atoms. For Ti, V, and Cr, however, a subsurface site, where the adatom substitutes a sixfold Ti atom, is more stable. The adatoms are oxidized in all cases. The charge transfer to the substrate is larger for the substitutional site than for the on-surface adsorption sites and decreases with atomic number along the 3d series. The relative stabilities of the adsorption sites are discussed in term…

Digital power conversion system based on a sigma-delta modulator linear model

2005

This paper presents a new linear model for the sigma-delta (/spl Sigma//spl Delta/) modulator, based on modeling the nonlinear quantizer with a linear factor, and its input-to-output transfer function is given. The use of a 1-bit sigma-delta modulator in DC/DC power converter systems permits to implement a complete digital control. Results of an investigation from a prototype for a DC-DC converter are here reported. Using of a field programmable gate array allows implementing a simple variable control function. The modulator output produces a variable-frequency variable duty-ratio signal to control the switching power transistors.

Structure and characteristics of laser crystallized thin amorphous Si films

2011

Abstract Pure amorphous Si thin films deposited on oxidized crystalline Si surface (111) were crystallized by picosecond UV laser pulses. The Raman scattering spectra show that pulse energy of 330 mJ/cm2 is enough to fully crystallize Si film and further increase of the energy does not improve crystallinity. A large grained polycrystalline Si was obtained as revealed by surface analysis. A significant increase in carrier mobility was observed after laser crystallization.

Role of the Back Metal-Semiconductor Contact on the Performances of a-Si:H Solar Cells

2011

We have investigated the role of the metal-semiconductor back contact on the performances of thin film modules consisting of single junction a-Si:H photovoltaic (PV) cells deposited with p-i-n configuration. We find that an adequate choice of the back contact helps reducing the barrier height of the junction improving the contact conductivity. For this purpose Mo has shown to be effective. Moreover we find that Mo, as refractory material, has additional beneficial effects reducing the formation of defects leading to the decrease of recombination losses. We have then fabricated a PV module on flexible substrate for indoor energy harvesting applications using Mo as back contact. An efficiency…

Post UV irradiation annealing of E’ centers in silica controlled by H2 diffusion

2004

Abstract We investigate the isothermal annealing of E′ centers generated by UV photons (266 nm) of a pulsed Nd:YAG laser in two natural silica types differing for their OH content. Electron spin resonance and absorption spectra recorded at room temperature at different delays from the laser exposure evidenced a partial reduction of E′ centers, more pronounced in the wet silica. These post irradiation kinetics complete within 10 5 s, regardless the silica type, and they are consistent with a diffusion limited reaction between the E′ centers and the molecular hydrogen H 2 . Analysis of our data is done by theoretical fits using the Waite's equation and compared with the H 2 diffusion paramete…