Search results for "Annealing"
showing 10 items of 434 documents
Elaboration and characterization of barium silicate thin films.
2008
International audience; Room temperature depositions of barium on a thermal silicon oxide layer were performed in ultra high vacuum (UHV). In-situ X-ray photoelectron spectroscopy (XPS) analyses were carried out as well after exposure to air as after subsequent annealings. These analyses were ex-situ completed by secondary ion mass spectrometry (SIMS) profiles and transmission electron microscopy (TEM) cross-sectional images. The results showed that after air exposure, the barium went carbonated. Annealing at sufficient temperature permitted to decompose the carbonate to benefit of a barium silicate. The silicate layer was formed by interdiffusion of barium with the initial SiO2 layer.
Experimental and theoretical evidence for substitutional molybdenum atoms in theTiO2(110)subsurface
2006
Molybdenum was deposited at room temperature on the ${\mathrm{TiO}}_{2}(110)$ surface in the 0--1.3 equivalent monolayer (eqML) range and was then annealed at $400\phantom{\rule{0.2em}{0ex}}\ifmmode^\circ\else\textdegree\fi{}\mathrm{C}$ in order to reach a kind of equilibrium state. A threshold was found in the behavior of the deposit: below 0.2 eqML, substitutional molybdenum occurs in titanium sites located under the bridging oxygen atoms of the ${\mathrm{TiO}}_{2}(110)$ surface. In this position, molybdenum atoms are in a structural and chemical ${\mathrm{MoO}}_{2}$-like environment. Density-functional theory calculations show that this molybdenum site is actually the most stable one in …
A diamond (1 0 0) surface with perfect phase purity
2015
Abstract Diamond surfaces with (1 0 0) orientation and perfect phase purity regarding the coexistence of sp3 and sp2 bonding as well as near surface nitrogen implanted layers are repeatedly produced from one sample by a cycle of nitrogen implantation, etching in oxygen and wet chemical etching. Comprehensive surface studies carried out by X-ray photoelectron spectroscopy (XPS) involving a deconvolution of the C 1s peak into contributions of C sp3, C sp2 and C sp3(N) reveal the surface and near-surface phase and stoichiometry. It is demonstrated that efficient etching of nitrogen implanted diamond occurs by high temperature annealing in oxygen and a wet chemical treatment.
Understanding the Conversion Process of Magnetron-Deposited Thin Films of Amorphous ReO$_x$ to Crystalline ReO$_3$ upon Thermal Annealing
2020
Crystal growth & design 20(9), 6147 - 6156 (2020). doi:10.1021/acs.cgd.0c00848
Efficient Vacuum-Deposited Perovskite Solar Cells with Stable Cubic FA 1– x MA x PbI 3
2020
Preparation of black formamidinium lead iodide (FAPbI3) requires high temperature annealing and the incorporation of smaller A-site cations, such as methylammonium (MA+), cesium or rubidium. A major advantage of vacuum processing is the possibility to deposit perovskite films at room temperature (RT), without any annealing step. Here we demonstrate stabilization of the cubic perovskite phase at RT, in a three-sources co-sublimation method. We found that the MA+ incorporation is a self-limiting process, where the amount of MA+ which is incorporated in the perovskite is essentially unvaried with increasing MAI deposition rate. In this way a phase-pure, cubic perovskite with a bandgap of 1.53 …
Positron annihilation studies of recrystallization in the subsurface zone induced by friction in magnesium—effect of the inhomogeneity on measured po…
2013
The discussion of the positron annihilation studies of crystal structure defects, like vacancies, dislocations, grain boundaries and the defect depth profile, is presented. The role of the positron implantation depth and positron diffusion in such studies has been considered in detail. For description of the measured annihilation characteristics the proposed theoretical models take into account both effects. The annealing studies of defects created in pure magnesium by compression or dry sliding-wear were used for demonstration of the discussed thesis. The positron lifetime measurements were applied for monitoring open volume defects behavior. It was demonstrated that annealing at the tempe…
Ru-Based Thin Film Temperature Sensor for Space Environments: Microfabrication and Characterization under Total Ionizing Dose
2016
The paper shows the microfabrication processes of a Ruthenium-based resistance temperature detector and its behavior in response to irradiation at ambient temperature. The radiation test was done in a public hospital facility and followed the procedures based on the ESA specification ESCC 22900. The instrumentation system used for the test is detailed in the work describing the sensors resistance evolution before, during, and after the exposure. A total irradiation dose of 43 krad with 36 krad/h dose rate was applied and a subsequent characterization was performed once the Ru sensors were submitted to an 80°C annealing process during a period of 168 h. The experimental measurements have sho…
Porphyrin Antenna-Enriched BODIPY–Thiophene Copolymer for Efficient Solar Cells
2018
International audience; Low bandgap A−π–D copolymer, P(BdP-DEHT), consisting of alternating BOronDIPYrromethene (BODIPY) and thiophene units bridged by ethynyl linkers, and its porphyrin-enriched analogue, P(BdP/Por-DEHT), were prepared, and their optical and electrochemical properties were studied. P(BdP-DEHT) exhibits strong absorption in the 500–800 nm range with an optical bandgap of 1.74 eV. On the basis of cyclic voltammetry, the highest occupied molecular orbital (HOMO) and lowest unoccupied molecular orbital (LUMO) energy levels are evaluated to be −5.40 and −3.66 eV, respectively. After the anchoring of zinc(II) porphyrin on the BODIPY unit, P(BdP/Por-DEHT) displays broadened absor…
CMOS-compatible field effect nanoscale gas-sensor: Operation and annealing models
2008
Complete modelling of electrically controlled nanoscale gas sensors with Poisson, Wolkenstein, Fokker-Planck and continuity is presented. Based on a plausible Drift explanation we developed suitable models for sensitivity control and operational modes. An onset for CMOS-complying annealing procedures is given.
Structural investigation of crystallized Ge-Ga-Se chalcogenide glasses
2018
H. Klym thanks to the Ministry of Education and Science of Ukraine for support and Dr. P. Demchenko for the assistance in XRD experiments.