Search results for "Bromide"

1975

In the polymerization of isobutene catalyzed by aluminium tribromide and in the polymerization of styrene catalyzed by trifluoromethanesulphonic acid it is supposed that an inactive catalyst monomer complex is formed which is in equilibrium with other active species. The monomer complexation of the catalyst explains the S-shaped conversion curves and the complex kinetics of the polymerization. The value of the equilibrium constant Km (complexation constant) expresses what part of the catalyst may take part in the polymerization process as an active initiating species. For the system isobutene/AlBr3, Km was found to be 0,62 1/mol. In the system styrene/CF3SO3H, the high value of the complexa…

Influence of synthesis conditions on the morphology of Dodecasil 1H

1993

Abstract The synthesis of Dodecasil 1H was studied in the system SiO2/1-adamantylamin/NH3/water with the objective of controlling the particle size and the morphology of the crystals. Since nucleation occurs in a very early stage of the synthesis, the heating rate to the final temperature and/or holding points during heat up have a strong influence on both parameters. Crystals smaller than 150 μm could only be obtained by the use of seed crystals, which are completely consumed in the synthesis with subsequent new nucleation. Using seed crystals, the expensive template 1-adamantylamine can be substituted with cheaper reagents such as sodium dodecyl sulfate or trimethylethylammonium bromide a…

Regioselective Synthesis of 2-Imino-1,3-thiazolidin-4-ones by Treatment ofN-(Anthracen-9-yl)-N′-ethylthiourea with Bromoacetic Acid Derivatives

2002

The reaction between N-(anthracen-9-yl)-N′-ethylthiourea (1) and methyl bromoacetate yielded mainly 2-[(anthracen-9-yl)imino]-3-ethyl-1,3-thiazolidin-4-one (2), together with some of the regioisomeric 3-(anthracen-9-yl)-2-ethylimino-1,3-thiazolidin-4-one (3). The structures of the products were elucidated by NMR techniques and, for 3, X-ray crystallographic analysis. Treatment of 1 with bromoacetyl bromide again yielded 2 and 3, but with a reversed product distribution ratio, thus providing an interesting and unexpected regioselectivity, depending on the electrophile selected. The underlying cause of the observed regioselectivity is a result of different reaction pathways taken by the two e…

Multi-Arm 1,2,3-Thiadiazole Systems

1997

Benzene derivatives 2a–c with 6, 4, and 3 side chains bearing terminal 1,2,3-thiadiazole rings, respectively, have been prepared. Alkaline cleavage of 2a–c led to the corresponding alkynethiolates 6a–c, which were trapped by electrophiles such as benzyl bromide or iodomethane. The method provides an alternative to the thermal or photochemical cleavage of 1,2,3-thiadiazoles to thioketenes, which react further with nucleophiles.

ChemInform Abstract: Elemental Bromine Production by TiO2Photocatalysis and/or Ozonation.

2016

Significant production of elemental bromine (Br2 ) was observed for the first time when treating bromide containing solutions at acidic pH, with TiO2 photocatalyst, ozone, or a combination thereof. Br2 selectivities up to approximately 85 % were obtained and the corresponding bromine mass balance values satisfied. The process is general and may be applied at a laboratory scale for green bromination reactions, or industrially as a cheap, safe, and environmentally sustainable alternative to the currently applied bromine production methods.

Über Serotoninderivate mit cyclisierter Seitenkette, 1. Mitt. Darstellung der isomeren 3-(Piperidylmethyl)- und 3-(Piperidylmethyl)-5-hydroxyindole

1975

Es wird die Synthese der drei isomeren 3-(Pyridylmethyl)- und 3-(Piperidylmethyl)-5-hydroxyindole beschrieben. Die 3-(Pyridilmethyl)-5-benzyloxyindole wurden durch Kondensation von 5-Benzyloxyindolylmagnesiumbromid mit den drei isomeren Chlormethyl-pyridinbasen dargestellt. Katalytische Reduktion ihrer quartaren Salze fuhrte zu den entsprechenden Piperidinverbindungen. Die 5-Benzyloxyindole wurden durch hydrierende Debenzylierung in die 5-Hydroxyindolverbindungen ubergefuhrt. 3-(Pyridylmethyl)- and 3-(Piperidylmethyl)-5-hydroxyindoles The synthesis of the three isomeric 3-(pyridylmethyl)- and the 3-(piperidylmethyl)-5-hydroxyindoles is described. To obtain the 3-(pyridylmethyl)-3-benzyloxyi…

ChemInform Abstract: Synthesis and Self-Assembly of Novel Fluorous Cationic Amphiphiles with a 3,4-Dihydro-2(1H)-pyridone Spacer.

2011

Abstract The synthesis of fluorous (highly fluorinated) 3,4-dihydro-2(1 H )-pyridone-5-carboxylate cationic amphiphiles have been described, where the dihydropyridone serves as a spacer and either a pyridinium bromide or a triphenylphosphonium bromide form the polar cationic head group. The in water self-assembled aggregates have been observed by atomic force microscopy (AFM) and dynamic light scattering (DLS).

Oxidative halogenation of substituted pyrroles with cu(II). Part I. Bromination of some 3-acetylpyrroles

1990

3-Acetylpyrroles are brominated with copper(II) bromide. The reaction afforded almost quantitatively only nuclear monobromination. Evidence for the structures of final compounds was by mass spectrometry, 1 H-nuclear magnetic resonance, ir, and elemental analysis

Oxidative halogenation of substituted pyrroles with cu(II). Part II. Bromination of some ethyl 3-pyrrolecarboxylates and corresponding acids

1990

Ethyl 3-pyrrolecarboxylates and their corresponding acids are brominated with copper(II) bromide. The reaction afforded at 0°, with high-yield nuclear monobromination.

Studien zum Vorgang der Wasserstoffübertragung, 41. Elektroreduktion von Acetophenon unter Mitwirkung optisch aktiver Leitsalze

1977

Die Anderung des Carbinol/Pinakol-Verhaltnisses2) (C/P) und der optischen Induktion bei der Elektroreduktion von Acetophenon mit (1 R, 2S)-N-(3-Cyanpropyl)-N-methylephedriniumbromid (1) und (1 R, 2 S)-N,N-Dimethylephedriniumbromid (2) als Leitsalze wird untersucht in Abhangigkeit: a) vom Potential (Tabelle 1), b) von der Stromdichte (Tabelle 2), c) von Pulsbedingungen (Tabelle 3), d) vom pH (Tabelle 4), e) von der Anwesenheit anderer Kationen (Tabelle 5), f) vom Losungsmittel (Tabelle 6), g) von der Temperatur (Tabelle 7) und h) von der Art des Elektrodenmaterials (Tabelle 8). — Es werden tensammetrische und cyclovoltammetrische Messungen durchgefuhrt. Die in trockenem Dimethylformamid erha…