Search results for "OEL"
showing 10 items of 5270 documents
Simultaneous polarization attraction and Raman amplification of a light beam in optical fibers
2012
International audience; In this paper, we demonstrate that it is possible to combine both Raman amplification and polarization attraction of a signal wave in a single optical fiber by means of a counterpropagating scheme. Experiments were performed near 1550 nm in a continuous wave regime and by means of a 10 Gbit ∕ s return-to-zero signal injected in a 20 kmlong low polarization mode dispersion optical fiber. Complete repolarization and 6.7 dB amplification of the signal wave was achieved by injecting a 850 mW, 1480 nm counterpropagating polarized pump wave.
The relevance of point defects in studying silica-based materials from bulk to nanosystems
2019
The macroscopic properties of silica can be modified by the presence of local microscopic modifications at the scale of the basic molecular units (point defects). Such defects can be generated during the production of glass, devices, or by the environments where the latter have to operate, impacting on the devices’ performance. For these reasons, the identification of defects, their generation processes, and the knowledge of their electrical and optical features are relevant for microelectronics and optoelectronics. The aim of this manuscript is to report some examples of how defects can be generated, how they can impact device performance, and how a defect species or a physical phenomenon …
Near‐IR Radiation‐Induced Attenuation of Aluminosilicate Optical Fibers
2021
The X-ray radiation-induced attenuation (RIA) growth kinetics are studied online in different single-mode aluminosilicate optical fibers in the near-IR (NIR) domain to evaluate their potential in terms of dosimetry. The optical fibers differ by Al contents, core sizes, drawing parameters, and also by a preform deposition process. The data show no dependence of the RIA on all these parameters, a positive result for the design of point or distributed radiation detectors exploiting RIA to monitor the dose. The RIA growth rate is unchanged for dose rates changing from 0.073 to 6.25 Gy(SiO2) s−1, and the RIA linearly increases with the dose up to 2 kGy(SiO2). Small but noticeable RIA changes are…
Ge quantum well plasmon-enhanced quantum confined Stark effect modulator
2014
ABSTRACTWe theoretically and experimentally investigate a novel modulation concept on silicon (Si) based on the combination of quantum confinement and plasmon enhancement effects. We experimentally study the suitability of Ge/SiGe quantum wells (QWs) on Si as the active material for a plasmon-enhanced optical modulator. We demonstrate that in QW structures absorption and modulation of light with transverse magnetic (TM) polarization are greatly enhanced due to favorable selection rules. Later, we theoretically study the plasmon propagation at the metal-Ge/SiGe QW interface. We design a novel Ge/SiGe QW structure that allows maximized overlap between the plasmonic mode and the underlying Ge/…
Evolution of microstructure and related optical properties of ZnO grown by atomic layer deposition.
2013
A study of transmittance and photoluminescence spectra on the growth of oxygen-rich ultra-thin ZnO films prepared by atomic layer deposition is reported. The structural transition from an amorphous to a polycrystalline state is observed upon increasing the thickness. The unusual behavior of the energy gap with thickness reflected by optical properties is attributed to the improvement of the crystalline structure resulting from a decreasing concentration of point defects at the growth of grains. The spectra of UV and visible photoluminescence emissions correspond to transitions near the band-edge and defect-related transitions. Additional emissions were observed from band-tail states near th…
Optical and structural properties of Al 2 O 3 /ZnO nanolaminates deposited by ALD method
2014
International audience; We report on the investigation of optical and structural properties of Al2O3/ZnO nanolaminates. The nanolaminates were deposited on Si and glass substrates by Atomic layer deposition method. Structural properties of nanolaminates were studied by SEM, GIXRD, and AFM. Optical characterization was performed by transmittance and photoluminescence spectroscopy. Complex analysis of monolayer properties was done by ellipsometry. Optical constants for Al2O3 and ZnO monolayer were calculated.
Atomic layer deposition of AlN from AlCl3 using NH3 and Ar/NH3 plasma
2018
The atomic layer deposition (ALD) of AlN from AlCl3 was investigated using a thermal process with NH3 and a plasma-enhanced (PE)ALD process with Ar/NH3 plasma. The growth was limited in the thermal process by the low reactivity of NH3, and impractically long pulses were required to reach saturation. Despite the plasma activation, the growth per cycle in the PEALD process was lower than that in the thermal process (0.4A ° vs 0.7A ° ). However, the plasma process resulted in a lower concentration of impurities in the films compared to the thermal process. Both the thermal and plasma processes yielded crystalline films; however, the degree of crystallinity was higher in the plasma process. The…
Unravelling the Intertwined Atomic and Bulk Nature of Localised Excitons by Attosecond Spectroscopy
2021
The electro-optical properties of most semiconductors and insulators of technological interest are dominated by the presence of electron-hole quasi-particles, called excitons. The manipulation of excitons in dielectrics has recently received great attention, with possible applications in different fields including optoelectronics and photonics. Here, we apply attosecond transient reflection spectroscopy in a sequential two-foci geometry and observe sub-femtosecond dynamics of a core-level exciton in bulk MgF2 single crystals. Furthermore, we access absolute phase delays, which allow for an unambiguous comparison with theoretical calculations. Our results show that excitons surprisingly exhi…
Low dimensional perovskite: synthetic methods and application in optoelectronics
2020
Through the end of contribute to the next generation of photovoltaics and light emitting devices the preparation of no-expensive and high quality materials with high PLQY and reduced non-radiative recombination is crucial. For such a reason the thesis is focus on the develop of high optoelectronic potential hybrid perovskite material and on their processing methods. In the different Chapters, various low dimensional perovskite synthetic approaches and their application are investigated. In the Chapter 2, a low dimension quasi-2D perovskite with a remarkable PLQY was prepared thanks to interplay of different fabrication approaches such us altered stoichiometry, solution engineered deposition…
Innovative Approaches for Light-Emitting Electrochemical Cells
2023
El uso de nuevos materiales, como las moléculas emisoras de luz o los polímeros transportadores de iones, tiene una importancia fundamental a la hora de mejorar la vida útil o de conseguir altos niveles de luminancia en dispositivos de tipo LEC. Al mismo tiempo, los avances más recientes han llevado a la tecnología LED y OLED a una nueva clase de dispositivos con propiedades atractivas, como la flexibilidad o la transparencia, desarrollo que se ha llevado a cabo de forma muy limitada en los LECs. Teniendo esto en cuenta, el trabajo de esta Tesis se centró en la implementación de nuevos materiales, en particular nuevos emisores iTMC y un polímero conductor iónico, y el diseño y fabricación d…