Search results for "Photoelectron spectroscopy"

Effect of the Mo atom flow on the molybdenum growth on TiO2 (110) surface

2004

Abstract Molybdenum has been deposited at room temperature on stoichiometric TiO 2 (1 1 0) surfaces with two deposition rates: 0.1 equivalent monolayer (eqML) and 1.5 eqML min −1 . X-ray photoelectron spectroscopy and high-resolution transmission electron microscopy studies clearly reveal an effect of the deposition rate upon the growth mode and the interfacial reaction. Indeed, whereas a strong interfacial reaction between Mo and TiO 2 involves a Stranski–Krastanov growth mode with the formation of amorphous molybdenum oxide monolayers for the lowest deposition rate, no reaction can be observed for the highest deposition rate. Moreover in this latter case, the growth mode seems to be a 3D …

Influence of fluorine on the synthesis of anatase TiO2for photocatalytic partial oxidation: Are exposed facets the main actors?

2018

Anatase TiO2 samples were synthesized in the presence of different amounts of HF acid with the aim of understanding the effect of the presence of fluorine on the photocatalytic activity. It is well known that the presence of fluoride ions influences the photocatalytic performance by adsorption on the surface of TiO2 and that they are capping agents in the control of specific exposed facets. The samples were characterized by X-ray diffraction (XRD), Raman spectroscopy, nitrogen adsorption–desorption measurements, scanning electron microscopy (SEM), transmission electron microscopy (TEM), UV-vis spectrophotometry, and X-ray photoelectron spectroscopy (XPS). The photocatalytic activity was eva…

Pulsed laser growth and characterization of thin films on titanium substrates

2007

Abstract Colored layers were obtained by laser surface treatment of Ti substrates with a pulsed Nd:YAG Q-switched laser. The changes in the morphology, structure and chemical composition of the layers were studied by SEM, EDS, XPS, SIMS and Raman spectroscopy as a function of the laser fluence in the 4–60 J cm −2 . For laser fluences lower than 25 J cm −2 , the layers are colorless or yellow. Their surface is smooth, but they display cracks which increase when the fluence increases. The O/Ti ratio, determined by XPS analysis, varies from 0.7 (colorless layers) to 1.3 (yellow layer). Moreover, XPS spectra evidence non-negligible amounts of nitrogen and carbon in these layers. Raman spectra s…

Nanostructured Pt–TiO2 composite thin films obtained by direct liquid injection metal organic chemical vapor deposition: Control of chemical state by…

2015

Abstract Nanostructured Pt–TiO 2 composite thin films were synthesized by direct liquid injection metal organic chemical vapor deposition process, using trimethyl(methylcyclopentadienyl)platinum and titanium isopropoxide as precursors. Surface and cross-sectional morphologies obtained by scanning electron microscopy and transmission electron microscopy evidenced the uniform distribution of platinum nanoparticles in the TiO 2 matrix. At higher Pt content, the X-ray diffraction analysis showed that the face-centered cubic phase of platinum appeared together with an anatase TiO 2 structure. In addition, as far as the platinum chemical state is concerned, the co-deposition of TiO 2 and Pt allow…

Preparation characterization and photocatalytic activity of polycrystalline ZnO/TiO2 systems. 1. Surface and bulk characterization

2001

Polycrystalline ZnO/TiO2 solids have been prepared with four different methods using home prepared TiO2 (anatase) or TiO2 (rutile) as supports and Zn(NO3)2·6H2O or Zn(CH3COO)2·2H2O as precursors for ZnO. The bulk and surface properties of the samples were investigated by means of TG-DTA, XRD, TEM, SEM-EDAX, XPS, BET surface area determination, and porosity measurements. XRD and TEM results indicate that no significant defect structures exist in any of the samples. The ZnO crystallinity and its enrichment on the surface of TiO2 particles were dependent on the preparation method. The surface areas generally decrease by increasing the amount of ZnO except when ZnO from Zn(CH3COO)2·2H2O was sup…

Mesocrystalline anatase nanoparticles synthesized using a simple hydrothermal approach with enhanced light harvesting for gas-phase reaction

2018

Mesocrystalline TiO2 nanoparticles were synthesized using a hydrothermal approach. A simple two-step procedure at low temperature (<140 °C) allowed the nucleation of primary particles sized 2–4 nm and their subsequent assembly as almost spherical aggregates sized ≈20 nm. X-ray powder diffraction (XRD), Raman and X-ray photoelectron spectroscopy (XPS) studies, and HRTEM studies confirmed anatase as the unique TiO2 crystalline phase. The mesocrystalline structure of the anatase aggregates was clearly evidenced by HRTEM and SAED results. The mesocrystalline nanopowders exhibit a mesoporous structure with a surface area and pore volume of 63.5 m2 g−1 and 0.22 cm3 g−1, respectively. Ultraviolet …

2018

We report a novel multi-step method for the preparation of ordered mesoporous titania scaffolds and show an illustrative example of their application to solar cells. The method is based on (monolayer) colloidal nanosphere lithography that makes use of polystyrene nanoparticles organised at a water–air interface and subsequently transferred onto a solid substrate. A titania precursor solution (titanium(IV) isopropoxide in ethanol) is then drop-cast onto the monolayer and left to “incubate” overnight. Surprisingly, instead of the expected inverse monolayer-structure, a subsequent calcination step of the precursor yields an ordered monolayer of hollow titania nanospheres with a wall thickness …

Thermal effects on the growth by metal organic chemical vapour deposition of TiO2 thin films on (100) GaAs substrates

2002

Abstract TiO 2 thin films were deposited on (100) GaAs substrates by LP-MOCVD with deposition temperatures ( T d ) ranking from 450 to 750 °C. The structure of these layers was studied by X-ray diffraction (XRD) and Raman spectroscopy. The growth of the TiO 2 anatase phase was observed for T d T d >600 °C. Finally, X-ray photoelectron spectrometry (XPS) and secondary ion mass spectroscopy (SIMS) experiments showed the presence of small quantities of Ga and As through the whole film thickness, slightly increasing at the surface of the layers. This result was related to the SEM observations and explained by considering the growth conditions.

Investigation on sol–gel synthesized Ag-doped TiO2 cermet thin films

2005

Abstract Undoped TiO 2 and Ag–TiO 2 (up to 23 at.% Ag) cermet thin films and polycrystalline powders have been prepared by sol–gel process. Their structure, composition, surface morphology and optical properties have been investigated by X-ray diffraction (XRD), differential thermal analysis (DTA), scanning electron microscopy (SEM), X-ray photoelectron spectroscopy (XPS), secondary ion mass spectrometry (SIMS) and ultraviolet–visible spectroscopy (UV–VIS spectroscopy). It has been observed that while Ag does not form a solid solution with TiO 2 , it promotes the anatase to rutile phase transformation. The transformation temperature decreases from 827 °C for undoped TiO 2 to about 650 °C fo…

TiO2 anatase films obtained by direct liquid injection atomic layer deposition at low temperature

2014

International audience; TiO2 thin films were grown by direct liquid injection atomic layer deposition (DLI-ALD) with infrared rapid thermal heating using titanium tetraisopropoxide and water as precursors. This titanium tetraisopropoxide/water process exhibited a growth rate of 0.018 nm/cycle in a self-limited ALD growth mode at 280 degrees C. Scanning electron microscopy and atomic force microscopy analyses have shown a smooth surface with a low roughness. XPS results demonstrated that the films were pure and close to the TiO2 stoichiometric composition in depth. Raman spectroscopy revealed that the films were crystallized to the anatase structure in the as-deposited state at low temperatu…