Search results for "Volt"
showing 10 items of 2187 documents
Nucleant layer effect on nanocolumnar ZnO films grown by electrodeposition
2013
Different ZnO nanostructured films were electrochemically grown, using an aqueous solution based on ZnCl2, on three types of transparent conductive oxides grow on commercial ITO (In2O3:Sn)-covered glass substrates: (1) ZnO prepared by spin coating, (2) ZnO prepared by direct current magnetron sputtering, and (3) commercial ITO-covered glass substrates. Although thin, these primary oxide layers play an important role on the properties of the nanostructured films grown on top of them. Additionally, these primary oxide layers prevent direct hole combination when used in optoelectronic devices. Structural and optical characterizations were carried out by scanning electron microscopy, atomic for…
Ultra-low density metallic foams synthesized by contact glow discharge electrolysis (CGDE) for laser experiments★
2018
International audience; The goal of this work is to realize metallic foams synthesized by contact glow discharge electrolysis with specific characteristics. In this paper, we show the results of our studies, consisting in investigating parameters that influence the foams characteristics. Thus, the morphology of metallic foams is examined through scanning electron microscopy (SEM) observations with the acid nature. Moreover, the evolution of the mass and the volume of metallic foams with two experimental parameters (overvoltage and gold concentration) is also investigated. The acid nature affects the foams microscopic structure highlighted by the SEM observations, but for now no valid explan…
Preparation of graphene nanocomposites from aqueous silver nitrate using graphene oxide’s peroxidase-like and carbocatalytic properties
2020
AbstractThe present study evaluates the role of graphene oxide’s (GO’s) peroxidase-like and inherent/carbocatalytic properties in oxidising silver nitrate (AgNO3) to create graphene nanocomposites with silver nanoparticles (GO/Ag nanocomposite). Activation of peroxidase-like catalytic function of GO required hydrogen peroxide (H2O2) and ammonia (NH3) in pH 4.0 disodium hydrogen phosphate (Na2HPO4). Carbocatalytic abilities of GO were triggered in pH 4.0 deionised distilled water (ddH2O). Transmission electron microscope (TEM), scanning electron microscope (SEM), cyclic voltammetry (CV) and UV-Vis spectroscopy aided in qualitatively and quantitatively assessing GO/Ag nanocomposites. TEM and …
Heavy-ion induced single event effects and latent damages in SiC power MOSFETs
2022
The advantages of silicon carbide (SiC) power MOSFETs make this technology attractive for space, avionics and high-energy accelerator applications. However, the current commercial technologies are still susceptible to Single Event Effects (SEEs) and latent damages induced by the radiation environment. Two types of latent damage were experimentally observed in commercial SiC power MOSFETs exposed to heavy-ions. One is observed at bias voltages just below the degradation onset and it involves the gate oxide. The other damage type is observed at bias voltages below the Single Event Burnout (SEB) limit, and it is attributed to alterations of the SiC crystal-lattice. Focused ion beam (FIB) and s…
Robustness and electrical reliability of AZO/Ag/AZO thin film after bending stress
2017
Abstract The increasing interest in thin flexible and bendable devices has led to a strong demand for mechanically robust and electrically reliable transparent electrodes. Indium doped Tin Oxide (ITO) and Aluminium doped Zinc Oxide (AZO) are among the most employed transparent conductive oxides (TCO) and their reliability on flexible substrates have thus received a great attention. However, a high flexibility is usually achieved at very low thickness, which, unfortunately, compromises the electrical conductivity. Here we report the effects of mechanical bending cycles on the electrical and optical properties of ultra thin AZO/Ag/AZO multilayers (45 nm/10 nm/45 nm) and, for comparison, of AZ…
Incident angle effect on heavy ion induced reverse leakage current in SiC Schottky diodes
2016
Heavy-ion induced degradation in the reverse leakage current of SiC Schottky power diodes shows distinct dependence on the angle of incidence. TCAD simulations have been used to study the physical mechanisms involved.
Manipulation of charge transfer and transport in plasmonic-ferroelectric hybrids for photoelectrochemical applications
2016
Utilizing plasmonic nanostructures for efficient and flexible conversion of solar energy into electricity or fuel presents a new paradigm in photovoltaics and photoelectrochemistry research. In a conventional photoelectrochemical cell, consisting of a plasmonic structure in contact with a semiconductor, the type of photoelectrochemical reaction is determined by the band bending at the semiconductor/electrolyte interface. The nature of the reaction is thus hard to tune. Here instead of using a semiconductor, we employed a ferroelectric material, Pb(Zr,Ti)O3 (PZT). By depositing gold nanoparticle arrays and PZT films on ITO substrates, and studying the photocurrent as well as the femtosecond …
Structural defects in Hg1−xCdxI2 layers grown on CdTe substrates by vapor phase epitaxy
1997
Hg1−xCdxI2 20–25-μm-thick layers with a uniform composition in the range of x = 0.1–0.2 were grown on CdTe substrates by vapor phase epitaxy (VPE). The growth was carried out using an α-HgI2 polycrystalline source at 200 °C and in the time range of 30–100 h. The layers were studied by scanning electron microscopy (SEM) and high resolution synchrotron x-ray topography (SXRT). The SEM and SXRT images of Hg1−xCdxI2 VPE layers allow one to identify the defects affecting the layer structure. The two main types of structural defects in the layers are subgrain boundaries and densely spaced striations similar to those referred generally to as vapor grown HgI2 bulk crystals. The effect of the growth…
Active Translucent Envelopes in Warm and Hot Areas – An innovative multifunctional, dry-assembled components for BIPV
2014
International directives that regulates buildings energy efficiency and environmental sustainability establish strict parameters for the construction of a new generation of “Zero Energy Buildings” indicating transmittance limits for building envelope components and encouraging the use of renewable sources. In this sense, the PV sector aims at the definition of novel efficient solutions for the integration in the building envelope, standing out for their multifunctional features. After an overview on the main PV technologies and building integrated applications, focusing on semi-transparent envelope solutions, the paper shows the results of a research carried out at the Department of Archite…
Photovoltaic facade: Comparison of actual technologies
2017
This article aims to establish the economic contribution of a photovoltaic system placed on a façade of a building, replacing traditional elements such as windows and glass-cement walls with active elements. The aim is to compare the behavior of next-generation systems, which favor architectonical integration, with traditional ones. Two novel systems have been taken into account: a dye sensitized solar cell (DSSC) and blue and grey thin film silicon panels. Different generation systems have been tested and compared in terms of efficiency and fill factor.