Search results for "a-Si:H"
showing 8 items of 8 documents
Plasmonic effects of ultra-thin Mo films on hydrogenated amorphous Si photovoltaic cells
2012
We report on the improvement of short circuit current (JSC), fill factor (FF), and open circuit resistance (ROC) in hydrogenated amorphous silicon (a-Si:H) photovoltaic cells with a p-type/intrinsic/n-type structure, achieved by the addition of an ultra-thin molybdenum film between the p-type film and the transparent conductive oxide/glass substrate. For suitable conditions, improvements of ≈10% in average internal quantum efficiency and up to 5%–10% under standard illumination in JSC, FF, and ROC are observed. These are attributed to the excitation of surface plasmon polariton modes of the a-Si:H/Mo interface.
Comparison between textured SnO2:F and Mo contacts with the p-type layer in p–i–n hydrogenate amorphous silicon solar cells by forward bias impedance…
2013
Abstract In this paper we compare the performance of the textured SnO2:F and Mo contacts with the p-type layer in p–i–n hydrogenate amorphous silicon (a-Si:H) solar cells. We use standard current–voltage (I–V) electrical characterization methods coupled with forward bias small signal impedance analysis. We show the efficacy of this technique to determine the effective carrier lifetime in photovoltaic cells. We show that such effective lifetimes are indeed directly connected to the respective dark diode saturation currents. We also find that the effective lifetime is constant with the temperature in the 0–70 °C range and it is significantly better for the solar cell with Mo diode contact. Th…
Instabilities Effects in Thin Film Solar Cells: Reversible Ageing, Performance Recovery and Improvement by Electrical Stresses
Role of the Back Metal-Semiconductor Contact on the Performances of a-Si:H Solar Cells
2011
We have investigated the role of the metal-semiconductor back contact on the performances of thin film modules consisting of single junction a-Si:H photovoltaic (PV) cells deposited with p-i-n configuration. We find that an adequate choice of the back contact helps reducing the barrier height of the junction improving the contact conductivity. For this purpose Mo has shown to be effective. Moreover we find that Mo, as refractory material, has additional beneficial effects reducing the formation of defects leading to the decrease of recombination losses. We have then fabricated a PV module on flexible substrate for indoor energy harvesting applications using Mo as back contact. An efficiency…
Post UV irradiation annealing of E’ centers in silica controlled by H2 diffusion
2004
Abstract We investigate the isothermal annealing of E′ centers generated by UV photons (266 nm) of a pulsed Nd:YAG laser in two natural silica types differing for their OH content. Electron spin resonance and absorption spectra recorded at room temperature at different delays from the laser exposure evidenced a partial reduction of E′ centers, more pronounced in the wet silica. These post irradiation kinetics complete within 10 5 s, regardless the silica type, and they are consistent with a diffusion limited reaction between the E′ centers and the molecular hydrogen H 2 . Analysis of our data is done by theoretical fits using the Waite's equation and compared with the H 2 diffusion paramete…
Broadband photocurrent enhancement in a-Si:H solar cells with plasmonic back reflectors
2014
The authors acknowledge Francesco Ruffino for the AFM measurements. This work was funded by the EU FP7 Marie Curie Action FP7-PEOPLE-2010-ITN through the PROPHET project (Grant No. 264687), the bilateral CNR/AVCR project "Photoresponse of nanostructures for advanced photovoltaic applications", the MIUR project Energetic (Grant no. PON02_00355_3391233) and by the Portuguese Science Foundation (FCT-MEC) through the Strategic Project PEst-C/CTM/LA0025/2013-14 and the research project PTDC/CTM-ENE/2514/2012. Plasmonic light trapping in thin film silicon solar cells is a promising route to achieve high efficiency with reduced volumes of semiconductor material. In this paper, we study the enhance…
Impact of transparent conductive oxide on the admittance of thin film solar cells
2010
Abstract The impact of transparent electrically conducting oxide (TCO) on the admittance measurements of thin film p–i–n a-Si:H solar cells was investigated. Admittance measurements on solar cell devices, with different area and geometry, in a wide range of frequencies and biases were performed. The admittance measurements of the investigated solar cells, which use the TCO as an electrical contact, showed that the high frequency admittance per area unit depends on the area. This effect increases both with the probe frequency and the size of the solar cells. Transmission line model valid for strip geometry which explains how the resistivity of the TCO layer impacts the measured admittance of…
Simulation studies of electronic transport in a-Si:H thin film solar cells
2009
The thin film solar cells in Hydrogenated Amorphous Silicon (a-Si:H) are attractive for cheaper production and used in ultra low cost, high volume applications but have a relatively lower electronic performance. These limitations are mainly due to properties of the a-Si:H and relies on the production technique. In this study we investigate the physical mechanisms which are on the basis of the electronic transport and their relation with the technological processes. The transport-simulation computer program ATLAS (Silvaco) has been used to examine the role of the mid gap defect density in determining the performance of a-Si:H p-i-n homojunction solar cell.