Search results for "phase transition"
showing 10 items of 1281 documents
Sublimation of icy aggregates in the coma of comet 67P/Churyumov–Gerasimenko detected with the OSIRIS cameras on board Rosetta
2016
Beginning in 2014 March, the OSIRIS (Optical, Spectroscopic, and Infrared Remote Imaging System) cameras began capturing images of the nucleus and coma (gas and dust) of comet 67P/Churyumov¿Gerasimenko using both the wide angle camera (WAC) and the narrow angle camera (NAC). The many observations taken since July of 2014 have been used to study the morphology, location, and temporal variation of the comet's dust jets. We analysed the dust monitoring observations shortly after the southern vernal equinox on 2015 May 30 and 31 with the WAC at the heliocentric distance Rh = 1.53 AU, where it is possible to observe that the jet rotates with the nucleus. We found that the decline of brightness a…
DIELECTRIC AND PIEZOELECTRIC PROPERTIES OF 0.8Na0.5 Bi0.5 TiO3-0.2BaTiO3 MODIFIED WITH SODIUM NIOBATE
2022
This work was supported by the Research Council of Lithuania (Project S-LLT-20-4). This work has been supported by Mutual Funds Taiwan–Latvia– Lithuania Cooperation Project Application LV-LT-TW/2020/10.
Pressure-Stabilized Solvates of Xylazine Hydrochloride
2016
High pressure strongly favors the highest-density polymorph Z of active pharmaceutical ingredient 2-(2,6-xylidino)-5,6-dihydro-4H-1,3-thiazine hydrochloride (xylazine hydrochloride, XylHCl) up to about 0.1 GPa only, but still higher pressure destabilizes this structure. Above 0.1 GPa, XylHCl preferentially crystallizes as solvates with CH2Cl2, CHCl3, or (CH3)2CHOH depending on the solvent used. However, when XylHCl·H2O is dissolved in any of these solvents, the high-pressure crystallizations yield the hydrate XylHCl·H2O only. The single crystals of the CH2Cl2, CHCl3, and (CH3)2CHOH solvates could be grown in situ in a diamond anvil cell, which allowed their structure determination from the …
On the effect of pressure on the phase transition of polymer blends and polymer solutions: Oligostyrene–n-alkane systems
2001
Critical temperatures of some binary solutions of weakly interacting low molecular weight polystyrenes dissolved in linear alkanes (oligoethylenes) were measured over the range 0.1 to 100 MPa. While (dT/dP)crit along the upper critical solution (UCS) locus for a “typical blend” is positive, and for the “ typical solution” can be either positive or negative (but is usually negative), there is no essential difference between blend and solution. Rather, the difference in sign is a consequence of the location of the hypercritical point (that point in (T,P)crit space where (dT/dP)crit changes sign, [(dT/dP)crit = 0 and (d2T/dP2)crit>0], also called the double critical point, DCP), which is norma…
Influence of melt flow and temperature on erosion of refractory and deposit formation in aluminium melting furnaces
2002
The deposition and erosion mechanism in induction-channel furnace for Al melting in alumino-silicate refractory is considered. The possibility of simultaneous erosion and deposition in the same cross-section of the channel is shown. The chemical reaction model causing the erosion of refractory is proposed. The erosion process is described by chemically active aluminium oxides while the deposition is caused by chemically stable aluminium oxides. The variations of erosion and deposition in the same cross-section of the channel are explained by variation of the thickness of laminar sub-layer along the perimeter.
Evaluation of Thin Film Microextraction for trace elemental analysis of liquid samples using LIBS detection
2021
An analytical methodology based in the combination of Thin Film Microextraction with Laser-induced Breakdown Spectroscopy (TFME-LIBS) was investigated, for the first time, for detection of Cu, Cr, Ni and Pb in aqueous solutions. In this methodology, the analytes were extracted in a thin film of adsorbent material deposited on a solid support, which was introduced in the sample to analyse. After extraction, the analytes retained in the adsorbent were analysed by LIBS. In order to obtain adsorbent films useful for the microextraction step, two different experimental procedures for film generation, denoted as Drop Casting Deposition and Mould Deposition, were evaluated. In both cases, graphene…
Thermal effects on the growth by metal organic chemical vapour deposition of TiO2 thin films on (100) GaAs substrates
2002
Abstract TiO 2 thin films were deposited on (100) GaAs substrates by LP-MOCVD with deposition temperatures ( T d ) ranking from 450 to 750 °C. The structure of these layers was studied by X-ray diffraction (XRD) and Raman spectroscopy. The growth of the TiO 2 anatase phase was observed for T d T d >600 °C. Finally, X-ray photoelectron spectrometry (XPS) and secondary ion mass spectroscopy (SIMS) experiments showed the presence of small quantities of Ga and As through the whole film thickness, slightly increasing at the surface of the layers. This result was related to the SEM observations and explained by considering the growth conditions.
Preparation and Characterization of Nanostructured Fe-TiO2 Thin Films Produced by Electrophoretic Deposition
2013
Fe-TiO2 thin films have been produced by a sol-electrophoretic deposition method on metallic Ti foil substrates. X-ray diffractograms and Raman spectra confirms the anatase structure of deposited and annealed Fe-TiO2 films. Obtained Fe-TiO2 thin films demonstrate photoactivity under visible light radiation due to the doping with Fe3+ ions. Open circuit potential results shows that increase of the film thickness and surface area improves the photoactivity of Fe-TiO2.
Structure and Phase Transitions in Ethylenediammonium Dichloride and its Salts with Antimony Trichloride
2000
During the mixing of ethylenediammonium dichloride and antimony trichloride except of reported earlier [NH3(CH2)2NH3]5(Sb2Cl11)2 · 4 H2O a new salt [NH3(CH2)2NH3](SbCl4)2 was obtained. The crystals are monoclinic at 295 K, space group C2/m, a = 13.829(3), b = 7.408(1), c = 7.588(2) A; β = 103.18(3)°; V = 756.9(3) A3; Z = 2; dc = 2.585, dm = 2.56(2) g · cm–3. The structure consists of anionic sublattice built of Sb2Cl82– units composed of two SbCl52– square pyramids connected by edge. The ethylenediammonium cations are located in anionic cavities. The cations are disordered. Each methylene carbon atom is split between two positions. The X-ray diffraction, DSC, TGA and dilatometric methods we…
Sb-implanted ZnO ultra-thin films
2017
Mild heating of the Zn(C5F6HO2)(2)center dot 2H(2)O center dot CH3(OCH2CH2)(2)OCH3 precursor allowed MOCVD deposition of ZnO films, in a low-pressure horizontal hot-wall reactor, on ITO substrates. The ZnO films were subsequently implanted with Sb ions. XRD measurements provided evidence that they consist of hexagonal, (002) and (101) oriented, crystals. UV-vis spectra showed that the transmittance of these films in the visible region is about 90%. The Sb implanted ZnO film showed a current-voltage characteristic that resembles that of a rectifying diode. This study represents the first example of Sb-implantation in ZnO films obtained by MOCVD.