0000000000076181
AUTHOR
Esa Puukilainen
showing 8 related works from this author
Evaluation and Comparison of Novel Precursors for Atomic Layer Deposition of Nb2O5 Thin Films
2012
Atomic layer deposition (ALD) of Nb2O5 thin films was studied using three novel precursors, namely, tBuN═Nb(NEt2)3, tBuN═Nb(NMeEt)3, and tamylN═Nb(OtBu)3. These precursors are liquid at room temperature, present good volatility, and are reactive toward both water and ozone as the oxygen sources. The deposition temperature was varied from 150 to 375 °C. ALD-type saturative growth modes were confirmed at 275 °C for tBuN═Nb(NEt2)3 and tBuN═Nb(NMeEt)3 together with both oxygen sources. Constant growth rate was observed between a temperature regions of 150 and 325 °C. By contrast, amylN═Nb(OtBu)3 exhibited limited thermal stability and thus a saturative growth mode was not achieved. All films we…
Atomic Layer Deposition of Ruthenium Films from (Ethylcyclopentadienyl)(pyrrolyl)ruthenium and Oxygen
2011
Ru films were grown by atomic layer deposition in the temperature range of 275―350°C using (ethylcyclopentadienyl)(pyrrolyl)ruthenium and air or oxygen as precursors on HF-etched Si, SiO 2 , ZrO 2 , and TiN substrates. Conformal growth was examined on three-dimensional silicon substrates with 20:1 aspect ratio. ZrO 2 promoted the nucleation of Ru most efficiently compared to other substrates, but the films roughened quickly on ZrO 2 with increasing film thickness. The minimum number of cycles required to form continuous and conductive metal layers could be decreased by increasing the length of the oxygen pulse. In order to obtain well-conducting Ru films growth to thicknesses of at least 8―…
Iridium metal and iridium oxide thin films grown by atomic layer deposition at low temperatures
2011
Atomic layer deposition (ALD) of both iridium and iridium oxide films at low temperatures has been studied and the resulting films have been examined by XRD, FESEM, XRR, EDX, AFM, TOF-ERDA, and four point probe measurements. Iridium oxide films were successfully grown using (MeCp)Ir(CHD) and ozone between 100 and 180 °C, however, the density of the films substantially reduced at 120 °C and below. The density reduction was accompanied by a phase change from crystalline to amorphous IrO2. Metallic iridium films were deposited between 120 and 180 °C by adding a reductive hydrogen pulse after the oxidative ozone pulse. Comparison of these processes with the earlier process employing the same Ir…
Low temperature atomic layer deposition of noble metals using ozone and molecular hydrogen as reactants
2013
Abstract Atomic layer deposition (ALD) of noble metals by thermal processes has relied mostly on the use of molecular oxygen as a reactant at temperatures of 200 °C and above. In this study, the concept of using consecutive ozone and molecular hydrogen pulses with noble metal precursors in ALD is introduced for palladium, rhodium, and platinum metals. This approach facilitates the growth of noble metal thin films below 200 °C. Also the ALD of palladium oxide thin films is demonstrated by the ozone-based chemistry. The growth rates, resistivities, crystallinities, surface roughnesses, impurity contents, and adhesion of the films to the underlying Al 2 O 3 starting surface are reported and th…
Atomic Layer Deposition of LiF Thin Films from Lithd, Mg(thd)2, and TiF4 Precursors
2013
Lithium fluoride is an interesting material because of its low refractive index and large band gap. Previously LiF thin films have been deposited mostly by physical methods. In this study a new way of depositing thin films of LiF using atomic layer deposition (ALD) is presented. Mg(thd)2, TiF4 and Lithd were used as precursors, and they produced crystalline LiF at a temperature range of 300–350 °C. The films were studied by UV–vis spectrometry, field emission scanning electron microscopy (FESEM), X-ray diffraction (XRD), atomic force microscopy (AFM), time-of-flight elastic recoil detection analysis (ToF-ERDA), and energy dispersive X-ray spectroscopy (EDX). In addition, film adhesion was t…
Atomic Layer Deposition of Osmium
2011
Growth of osmium thin films and nanoparticles by atomic layer deposition is described. The Os thin films were successfully grown between 325 and 375 °C using osmocene and molecular oxygen as precursors. The films consisted of only Os metal as osmium oxides were not detected in X-ray diffraction measurements. Also the impurity contents of oxygen, carbon, and hydrogen were less than 1 at % each at all deposition temperatures. The long nucleation delay of the Os process facilitates either Os nanoparticle or thin film deposition. However, after the nucleation delay of about 350 cycles the film growth proceeded linearly with increasing number of deposition cycles. Also conformal growth of Os thi…
Studies on atomic layer deposition of IRMOF-8 thin films
2015
Deposition of IRMOF-8 thin films by atomic layer deposition was studied at 260–320 C. Zinc acetate and 2,6-naphthalenedicarboxylic acid were used as the precursors. The as-deposited amorphous films were crystallized in 70% relative humidity at room temperature resulting in an unknown phase with a large unit cell. An autoclave with dimethylformamide as the solvent was used to recrystallize the films into IRMOF-8 as confirmed by grazing incidence x-ray diffraction. The films were further characterized by high temperature x-ray diffraction (HTXRD), field emission scanning electron microscopy, Fourier transform infrared spectroscopy (FTIR), time-of-flight elastic recoil detection analysis (TOF-…
Studies on atomic layer deposition of MOF-5 thin films
2013
International audience; Deposition of MOF-5 thin films from vapor phase by atomic layer deposition (ALD) was studied at 225-350 degrees C. Zinc acetate (ZnAc2) and 1,4-benzenedicarboxylic acid (1,4-BDC) were used as the precursors. The resulting films were characterized by UV-Vis spectrophotometry, Fourier transform infrared spectroscopy (FTIR), optical microscopy, X-ray diffraction (XRD), field emission scanning electron microscopy (FESEM), time-of-flight elastic recoil detection analysis (TOF-ERDA), isopropanol adsorption tests, and nanoindentation. It was found out that the as-deposited films were amorphous but crystallized in humid conditions at room temperature. The crystalline films h…