Search results for "BD"
showing 10 items of 3363 documents
Reactive Sintering of molybdenum disilicide by Spark Plasma Sintering from mechanically activated powder mixtures: Processing parameters and properti…
2008
Abstract Dense molybdenum disilicide with a nano-organized microstructure was synthesized by mechanical activation, by producing nanostructured agglomerates of a 1:2 mixture of Mo and Si, followed by the synthesis/consolidation in one step using SPS technology. In order to synthesize a dense molybdenum disilicide with a perfectly controlled microstructure, an investigation of the influence of Spark Plasma Sintering processing parameters (temperature, heating rate, mechanical pressure and holding time) on the chemical composition and the microstructure characteristics has been performed. The present work shows also that the so-obtained materials present better oxidation resistance in compari…
Current Spreading Length and Injection Efficiency in ZnO/GaN-Based Light-Emitting Diodes
2019
We report on carrier injection features in light-emitting diodes (LEDs) based on nonintentionally doped-ZnO/p-GaN heterostructures. These LEDs consist of a ZnO layer grown by chemical-bath deposition (CBD) onto a p-GaN template without using any seed layer. The ZnO layer (~1- $\mu \text{m}$ thickness) consists of a dense collection of partially coalesced ZnO nanorods, organized in wurtzite phase with marked vertical orientation, whose density depends on the concentration of the solution during the CBD process. Due to the limited conductivity of the p-GaN layer, the recombination in the n-region is strongly dependent on the spreading length of the holes, ${L}_{h}$ , coming from the p-contact…
Silicon dosimeters based on Floating Gate Sensor: design, implementation and characterization
2020
A rad-hard monolithic dosimeter has been implemented and characterized in a standard 180 nm CMOS technology. The radiation sensor (C-sensor) is based on a Floating Gate (FG) MOS discharge principle. The output current is processed by a current-to-voltage (I/V) interface and then converted by a 5-bit flash ADC. The dosimeter is re-usable (FG can be recharged) and can detect a dose up to 1krad (Si) with a resolution of 30rad (Si) typical over temperature 0 to 85°C range. The ADC allows easy further signal processing for calibration and averaging, etc. The power consumption of C-sensor plus I/V interface is < 2mW from a 5 V power supply. The overall layout area is less than 0.25mm2. The Rad…
Catalytic epoxidation using dioxidomolybdenum(VI) complexes with tridentate aminoalcohol phenol ligands
2019
Reaction of the tridentate aminoalcohol phenol ligands 2,4-di-tert-butyl-6-(((2 hydroxyethyl)(methyl)amino)methyl)phenol (H2L1) and 2,4-di-tert-butyl-6-(((1-hydroxybutan-2-yl)amino)methyl)phenol (H2L2) with [MoO2(acac)2] in methanol solutions resulted in the formation of [MoO2(L1)(MeOH)] (1) and [MoO2(L2)(MeOH)] (3), respectively. In contrast, the analogous reactions in acetonitrile afforded the dinuclear complexes [Mo2O2(μ-O)2(L1)2] (2) and [Mo2O2(μ-O)2(L2)2] (4). The corresponding reactions with the potentially tetradentate ligand 3-((3,5-di-tert-butyl-2-hydroxybenzyl)(methyl)amino)propane-1,2-diol (H3L3) led to the formation of the mononuclear complex [MoO2(L3)(MeOH)] (5) in methanol whi…
Mild, Fast, and Easy To Conduct MoCl5-Mediated Dehydrogenative Coupling Reactions in Flow
2018
A convenient and straightforward approach to performing oxidative coupling reactions in flow is presented. A collection of electron-rich benzene derivatives was subjected to this protocol, and the distinct utility of molybdenum pentachloride (MoCl5) is established. Using this unexplored protocol, biphenyls could be obtained in 21–91% isolated yield. This simple protocol opens a new chapter in reagent-mediated dehydrogenative coupling reactions, and yields are compared to classical approaches.
Half-sandwich complexes of molybdenum-(III), -(IV) and -(V) with P–O and P–N bifunctional ligands Ph2PCH2X (X = 2-oxazolinyl, or C(O)NPh2)
2000
International audience; The reaction of the ligands Ph2PCH2X (X = 2-oxazolinyl, I; or C(O)NPh2, II) with the half-sandwich molybdenum(III) precursors [Mo(η-C5R5)(μ-Cl)2]2 (R = H or Me) has been investigated. Ligand I reacts with both complexes to form the corresponding adducts [Mo(η-C5R5)Cl2(Ph2PCH2C3H4NO)] (R = H, 1; or Me, 2). The reaction between I and [MoCp*Cl4] (Cp* = η-C5Me5) affords [MoCp*Cl4(Ph2PCH2C3H4NO-κ1P)] as a kinetic isomer, which then transforms quantitatively to [MoCp*Cl3(Ph2PCH2C3H4NO-κ2P,N)]+Cl−, 3. Ligand II reacts with [MoCp(μ-Cl)2]2 (Cp = η-C5H5) to afford the adduct [CpMoCl2{Ph2PCH2C(O)NPh2-κ2P,O}], 4, as an equilibrium mixture of two isomers. Longer reaction times in…
Synthesis, molecular structures and EPR spectra of the paramagnetic cuboidal clusters with Mo3S4Ga cores
2017
Electron precise [Mo3(l3-S)(l-S)3(diphos)3Br3]Br (diphos = dppe, dmpe) incomplete cuboidal clusters with six cluster skeletal electrons (CSE) were converted into paramagnetic cuboidal [Mo3(GaBr)(l3-S)4- (diphos)3Br3] clusters by treatment with elemental Ga. The new heterobimetallic complexes with nine CSE possess a doublet ground state with the unpaired electron density delocalized over the three molybdenum atoms.
Studies on the Reduction of [(C 5 Me 5 ) 2 Mo 2 O 5 ] in Methanol/Water/Acetate Solutions by On‐Line Electrochemical Flowcell and Electrospray Mass S…
2003
The complex [Cp*2Mo2O5] (Cp* = η5-C5Me5) and its electrochemical reduction products in acetic acid/acetate-buffered (pH = 4.0) water/methanol solutions were investigated by combined electrochemical (EC) flowcell and on-line electrospray ionization mass spectrometry (ESI-MS). Mono-, di-, tri-, and tetranuclear organometallic molybdenum oxides were identified in the starting solution. The effect of the relevant ESI-MS parameters (ionic mode, heated capillary voltage, and heated capillary temperature) and of the concentration on the observed distribution of ions in the mass spectrometer was studied in order to minimize side reactions in the ESI chamber. It was verified that reduction in the ES…
Gas phase heterogeneous partial oxidation reactions
2018
Abstract Mixed metal oxides are used as catalysts in the gas phase partial oxidation of hydrocarbons. This paper will present the principles of catalyst choice for selective oxidation reactions as well as the structural features of metal oxide catalysts. The nature of active sites in selective oxidation reactions will also be briefly discussed. We will pay special attention to several representative reactions: (1) ODH of short chain alkanes (from C1 to C4), (2) propene partial oxidation/ammoxidation on bismuth molybdate based catalysts, (3) n-butane direct oxidation to maleic anhydride on VPO type catalysts, and (4) propane direct oxidation/ammoxidation on mixed MoVTe(Sb)Nb–O catalysts. Fin…
Molybdenum Pentachloride Mediated Synthesis of Spirocyclic Compounds by Intramolecular Oxidative Coupling
2015
The oxidative treatment of (m)ethyl 2-aryl cinnamates equipped with methoxy groups in position 4 of the phenyl moiety promote the formation of cyclohexadienone substructures. This dealkylative oxidative C–C coupling gives access to spirocyclic compounds and avoids the construction of the corresponding phenanthrenes. Furthermore, the transformation can be expanded to other spirocyclic systems.