Search results for "Nanoestructures"

showing 10 items of 24 documents

Should TiO2 nanostructures doped with Li+ be used as photoanodes for photoelectrochemical water splitting applications?

2017

[EN] Different TiO2 nanostructures, nanotubes and nanosponges, were obtained by anodization of Ti under stagnant and hydrodynamic conditions. Samples were doped with Li+ before and after annealing at 450 degrees C during 1 h. The nanostructures were characterized by different microscopy techniques: Field Emission Scanning Electron Microscopy (FE-SEM) and Raman Confocal Laser Microscopy. Additionally, Incident Photon-to-electron Conversion Efficiency (IPCE), photoelectrochemical water splitting and stability measurements were also performed. According to the results, TiO2 nanostructures doped before annealing present the worst photocurrent response, even if compared with undoped samples. On …

Annealing (metallurgy)Nanotechnology02 engineering and technology010402 general chemistry01 natural sciencesCatalysisINGENIERIA QUIMICAAnnealingsymbols.namesakechemistry.chemical_compoundMicroscopyPhysical and Theoretical ChemistryWater splittingPhotocurrentNanoestructuresbusiness.industryChemistryEnergy conversion efficiencyDoping021001 nanoscience & nanotechnology0104 chemical sciencesNanostructuresElectroquímicaTitanium dioxidesymbolsWater splittingOptoelectronicsTitanium dioxideLi+ insertion0210 nano-technologybusinessRaman spectroscopy
researchProduct

Ruddlesden-Popper Hybrid Lead Bromide Perovskite Nanosheets of Phase Pure n=2: Stabilized Colloids Stored in the Solid State.

2021

Ruddlesden-Popper lead halide perovskite (RP-LHP) nano-nanostructures can be regarded as self-assembled quantum wells or superlattices of 3D perovskites with an intrinsic quantum well thickness of a single or a few (n=2-4) lead halide layers; the quantum wells are separated by organic layers. They can be scaled down to a single quantum well dimension. Here, the preparation of highly (photo)chemical and colloidal stable hybrid LHP nanosheets (NSs) of ca. 7.4 μm lateral size and 2.5 nm quantum well height (thereby presenting a deep blue emission at ca. 440 nm), is reported for the first time. The NSs are close-lying and they even interconnect when deposited on a substrate. Their synthesis is …

Col·loidesNanoestructuresPhotoluminescenceMaterials scienceSuperlatticeHalideGeneral Medicine02 engineering and technologyGeneral Chemistry010402 general chemistry021001 nanoscience & nanotechnology01 natural sciencesCatalysis0104 chemical sciencesColloidChemical engineeringPhase (matter)Nanodot0210 nano-technologyQuantum wellPerovskite (structure)Angewandte Chemie (International ed. in English)
researchProduct

A simple method to fabricate high-performance nanostructured WO3 photocatalysts with adjusted morphology in the presence of complexing agents

2017

[EN] The rich and complex chemistry of tungsten was employed to synthesize innovative WO3 nanoplatelets/nanosheets by simple anodization in acidic electrolytes containing different concentrations of complexing agents or ligands, namely F- and H2O2. The morphological and photoelectrochemical properties of these nanostructures were characterized. The best of these nanostructures generated stable photocurrent densities of ca. 1.8 mA cm(-2) at relatively low bias potentials (for WO3) of 0.7 V-Ag/AgCl under simulated solar irradiation, which can be attributed to a very high active surface area. This work demonstrates that the morphology and dimensions of these nanostructures, as well as their ph…

Complexing agentsNanostructureMaterials sciencechemistry.chemical_elementNanotechnology02 engineering and technologyElectrolyteTungsten010402 general chemistryElectrochemistry01 natural sciencesINGENIERIA QUIMICACatalysisSynthesislcsh:TA401-492General Materials SciencePhotocatalysisPhotocurrentNanoestructuresAnodizingMechanical EngineeringHydrogen peroxide021001 nanoscience & nanotechnologyWO3 nanostructures0104 chemical sciencesElectroquímicachemistryMechanics of MaterialsPhotocatalysislcsh:Materials of engineering and construction. Mechanics of materialsAnodization0210 nano-technology
researchProduct

Study of the annealing conditions and photoelectrochemical characterization of a new iron oxide bi-layered nanostructure for water splitting

2016

Iron oxide nanostructures have emerged as promising materials for being used as photocatalysts for hydrogen production due to their advantageous properties. However, their low carrier mobility and short hole diffusion length limit their efficiency in water splitting. To overcome these drawbacks, in the present study, we synthetized a new hematite (alpha-Fe2O3) bi-layered nanostructure consisting of a top nanosphere layer and a nanotubular underneath one by electrochemical anodization. Annealing parameters such as temperature, heating rate and atmosphere were studied in detail in order to determine the optimum annealing conditions for the synthetized nanostructure. The obtained new bi-layere…

Electron mobilityNanostructureMaterials scienceAnnealing (metallurgy)HematiteNanotechnology02 engineering and technology010402 general chemistry01 natural sciencesINGENIERIA QUIMICAAnnealingsymbols.namesakeWater splittingPhotocurrentNanoestructuresRenewable Energy Sustainability and the EnvironmentAnodizingPhotocatalyst021001 nanoscience & nanotechnology0104 chemical sciencesSurfaces Coatings and FilmsElectronic Optical and Magnetic MaterialsDielectric spectroscopyElectroquímicaChemical engineeringsymbolsWater splittingAnodization0210 nano-technologyRaman spectroscopy
researchProduct

Photoelectrocatalyzed degradation of a pesticides mixture solution (chlorfenvinphos and bromacil) by WO3 nanosheets

2019

[EN] A photoelectrocatalyst consisting of WO3 nanosheets or nanorods has been synthesized by electrochemical anodization under hydrodynamic conditions, and has been used for the degradation of two toxic pesticides: chlorfenvinphos and bromacil. Nanostructures have been characterized by FESEM and Raman spectroscopy. Photoelectrochemical degradation tests have been carried out both for individual pesticide solutions and for a mixture solution, and the concentration evolution with time has been followed by UV¿Vis spectrophotometry. For individual pesticides, pseudo-first order kinetic coefficients of 0.402 h¿1 and 0.324 h¿1 have been obtained for chlorfenvinphos and bromacil, respectively, whi…

Environmental Engineering010504 meteorology & atmospheric sciencesPhotoelectrochemistryElectrolyte010501 environmental sciences01 natural sciencesINGENIERIA QUIMICAsymbols.namesakechemistry.chemical_compoundPhotoelectrochemistryBromacilSpectrophotometrymedicineEnvironmental ChemistryWater treatmentPesticidesWaste Management and Disposal0105 earth and related environmental sciencesNanoestructuresmedicine.diagnostic_testChlorfenvinphosPollutionWO3 nanostructuresElectroquímicachemistryChemical engineeringsymbolsPesticide degradationDegradation (geology)Raman spectroscopy
researchProduct

Visible-light photoelectrodegradation of diuron on WO3 nanostructures

2018

[EN] The degradation of pesticide diuron has been explored by photoelectrocatalysis (PEC) under visible light illumination using two different WO3 nanostructures, obtained by anodization of tungsten. The highest degradation efficiency (73%) was obtained for WO3 nanosheets synthesized in the presence of small amounts of hydrogen peroxide (0.05 M). For that nanostructure, the kinetic coefficient for diuron degradation was 133% higher than that for the other nanostructure (anodized in the presence of fluoride anions). These results have been explained by taking into account the different architecture and dimensions of the two WO3 nanostructures under study.

Environmental EngineeringMaterials scienceNanostructurechemistry.chemical_element02 engineering and technology010501 environmental sciencesManagement Monitoring Policy and LawTungsten01 natural sciencesINGENIERIA QUIMICAchemistry.chemical_compoundPesticidesHydrogen peroxideWaste Management and Disposal0105 earth and related environmental sciencesNanoestructuresAnodizingGeneral Medicine021001 nanoscience & nanotechnologyWO3 nanostructures AnodizationElectroquímicachemistryChemical engineeringDiuronKinetic coefficientDegradation (geology)Photoelectrocatalysis0210 nano-technologyFluorideVisible spectrum
researchProduct

Photoelectrocatalyzed degradation of organophosphorus pesticide fenamiphos using WO3 nanorods as photoanode

2020

[EN] In this study, WO3 nanostructures were synthesized by the electrochemical anodization technique to use them on the degradation of persistent organic compounds such as the pesticide fenamiphos. The acids electrolyte used during the anodization were two different: 1.5 M H2SO4-0.05 M H2O2 and 1.5 M CH4O3S-0.05 M H2O2. Once the samples have been manufactured, they have been subjected to different tests to analyze the properties of the nanostructures. With Field Emission Scanning Electron Microscopy (FESEM) the samples have been examined morphologically, their composition and crystallinity has been studied through Raman Spectroscopy and their photoelectrochemical behaviour by Photoelectroch…

InsecticidesEnvironmental EngineeringMaterials scienceHealth Toxicology and Mutagenesis0208 environmental biotechnology02 engineering and technologyElectrolyte010501 environmental sciences01 natural sciencesINGENIERIA QUIMICAchemistry.chemical_compoundCrystallinitysymbols.namesakeDegradationEnvironmental ChemistryFenamiphos0105 earth and related environmental sciencesNanoestructuresWO3 nanostructureAnodizingPublic Health Environmental and Occupational HealthGeneral MedicineGeneral ChemistryPollution020801 environmental engineeringDielectric spectroscopyPesticideChemical engineeringchemistrysymbolsDegradation (geology)NanorodPhotoelectrocatalysisRaman spectroscopyFenamiphos
researchProduct

Cathodoluminescence characterization of ZnO/ZnS nanostructures anodized under hydrodynamic conditions

2018

[EN] ZnO/ZnS nanostructures were successfully synthesized by a simple electrochemical anodization of zinc in a glycerol based electrolyte containing sulfide-ammonium fluoride. The influence of different hydrodynamic conditions and anodization potentials during anodization on the morphological and electronic properties of the obtained ZnO/ZnS nanostructures was studied. The anodized samples were characterized using confocal Raman microscopy, X-Ray Diffraction (XRD), Field Emission Scanning Electronic Microscopy (FE-SEM), cathodoluminescence (CL), and photoelectrochemical water splitting tests under standard AM 1.5 conditions. The results showed that hydrodynamic conditions and higher potenti…

Materials scienceCathodoluminescenceGeneral Chemical EngineeringCathodoluminescenceZnO/ZnS nanostructure02 engineering and technology010402 general chemistry01 natural sciencesINGENIERIA QUIMICAsymbols.namesakeMicroscopyElectrochemistryWater splittingPhotocurrentNanoestructuresAnodizingPhotocatalyst021001 nanoscience & nanotechnology0104 chemical sciencesElectroquímicaField electron emissionChemical engineeringsymbolsPhotocatalysisWater splittingAnodization0210 nano-technologyRaman spectroscopy
researchProduct

Novel tree-like WO3 nanoplatelets with very high surface area synthesized by anodization under controlled hydrodynamic conditions

2016

In the present work, a new WO3 nanostructure has been obtained by anodization in a H2SO4/NaF electrolyte under controlled hydrodynamic conditions using a Rotating Disk Electrode (RDE) configuration. Anodized samples were analyzed by means of Field Emission Scanning Electronic Microscopy (FESEM), Confocal Raman Microscopy and photoelectrochemical measurements. The new nanostructure, which consists of nanoplatelets clusters growing in a tree-like manner, presents a very high surface area exposed to the electrolyte, leading to an outstanding enhancement of its photoelectrochemical activity. Obtained results show that the size of nanostructures and the percentage of electrode surface covered by…

Materials scienceNanostructureAcid electrolytesGeneral Chemical EngineeringNanotechnology02 engineering and technologyElectrolyte010402 general chemistry01 natural sciencesIndustrial and Manufacturing EngineeringINGENIERIA QUIMICAsymbols.namesakeMicroscopyEnvironmental ChemistryRotating disk electrodeWater splittingNanoestructuresAnodizingHidrodinàmicaGeneral Chemistry021001 nanoscience & nanotechnologyWO3 nanostructures0104 chemical sciencesHydrodynamic conditionsField electron emissionChemical engineeringElectrodesymbolsAnodization0210 nano-technologyRaman spectroscopy
researchProduct

Influence of electrolyte temperature on the synthesis of iron oxide nanostructures by electrochemical anodization for water splitting

2018

[EN] Iron oxide nanostructures are an attractive option for being used as photocatalyst in photoelectrochemical applications such as water splitting for hydrogen production. Nanostructures can be obtained by different techniques, and electrochemical anodization is one of the simplest methods which allows high control of the obtained morphology by controlling its different operational parameters. In the present study, the influence of the electrolyte temperature during electrochemical anodization under stagnant and hydrodynamic conditions was evaluated. Temperature considerably affected the morphology of the obtained nanostructures and their photoelectrochemical behavior. Several techniques …

Materials scienceNanostructureAnnealing (metallurgy)Iron oxideEnergy Engineering and Power Technology02 engineering and technologyElectrolyte010402 general chemistry01 natural sciencesINGENIERIA QUIMICAsymbols.namesakechemistry.chemical_compoundElectrolyte temperatureIron oxideElectrochemical anodizationWater splittingHydrogen productionPhotocurrentNanoestructuresRenewable Energy Sustainability and the Environment021001 nanoscience & nanotechnologyCondensed Matter Physics0104 chemical sciencesElectroquímicaFuel TechnologyChemical engineeringchemistryPhotocatalysissymbolsWater splitting0210 nano-technologyRaman spectroscopy
researchProduct