Search results for "electronics"
showing 10 items of 4340 documents
Noncovalent force spectroscopy using wide-field optical and diamond-based magnetic imaging
2019
A realization of the force-induced remnant magnetization spectroscopy (FIRMS) technique of specific biomolecular binding is presented where detection is accomplished with wide-field optical and diamond-based magnetometry using an ensemble of nitrogen-vacancy (NV) color centers. The technique may be adapted for massively parallel screening of arrays of nanoscale samples.
Two-dimensional nuclear magnetic resonance spectroscopy with a microfluidic diamond quantum sensor
2019
Quantum sensors based on nitrogen-vacancy centers in diamond have emerged as a promising detection modality for nuclear magnetic resonance (NMR) spectroscopy owing to their micron-scale detection volume and non-inductive based detection. A remaining challenge is to realize sufficiently high spectral resolution and concentration sensitivity for multidimensional NMR analysis of picoliter sample volumes. Here, we address this challenge by spatially separating the polarization and detection phases of the experiment in a microfluidic platform. We realize a spectral resolution of 0.65 +/- 0.05 Hz, an order-of-magnitude improvement over previous diamond NMR studies. We use the platform to perform …
Superconductor-ferromagnet tunnel junction thermoelectric bolometer and calorimeter with a SQUID readout
2020
Superconductor-ferromagnet thermoelectric detector (SFTED) is a novel ultrasensitive radiation detector based on the giant thermoelectric effect in superconductor-ferromagnet tunnel junctions. This type of detector can be operated without the need of additional bias lines, and is predicted to provide a performance rivaling transition-edge sensors and kinetic inductance detectors. Here we report our numerical studies on the SFTED noise equivalent power, energy resolution and time constant, and the feasibility of a SQUID readout in both bolometric and calorimetric regimes, with the goal to provide practical design parameters for the detector fabrication and the readout circuitry implementatio…
Electronic structure of delta-doped $La:SrTiO_{3}$ layers by hard X-ray photoelectron spectroscopy
2012
We have employed hard x-ray photoemission (HAXPES) to study a delta-doped SrTiO3 layer that consisted of a 3-nm thickness of La-doped SrTiO3 with 6% La embedded in a SrTiO3 film. Results are compared to a thick, uniformily doped La:SrTiO3 layer. We find no indication of a band offset for the delta-doped layer, but evidence of the presence of Ti3+ in both the thick sample and the delta-layer, and indications of a density of states increase near the Fermi energy in the delta-doped layer. These results further demonstrate that HAXPES is a powerful tool for the non-destructive investigation of deeply buried doped layers.
Pre-determining the location of electromigrated gaps by nonlinear optical imaging
2014
In this paper we describe a nonlinear imaging method employed to spatially map the occurrence of constrictions occurring on an electrically-stressed gold nanowire. The approach consists at measuring the influence of a tightly focused ultrafast pulsed laser on the electronic transport in the nanowire. We found that structural defects distributed along the nanowire are efficient nonlinear optical sources of radiation and that the differential conductance is significantly decreased when the laser is incident on such electrically-induced morphological changes. This imaging technique is applied to pre-determined the location of the electrical failure before it occurs.
Conductance control at the LaAlO3/SrTiO3-interface by a multiferroic BiFeO3 ad-layer
2014
Multilayered BiFeO3 (BFO)/LaAlO3 (LAO) thin film samples were fabricated on SrTiO3 (STO) substrates by pulsed laser deposition. In this work, the ferroelectric polarization of a multiferroic BFO ad-layer on top of the quasi-two-dimensional electron gas (2DEG) at the LAO/STO interface is used to manipulate the conductivity of the quasi-2DEG. By microstructuring the conductive area of the LAO/STO-interface, a four-point geometry for the measurement of the resistivity was achieved. Piezo force microscopy allows for imaging and poling the spontaneous ferroelectric polarization of the multiferroic layer. The resistance changes showed a linear dependence on the area scanned and a hysteretic behav…
Dopant-controlled single-electron pumping through a metallic island
2016
We investigate a hybrid metallic island/single dopant electron pump based on fully depleted silicon-on-insulator technology. Electron transfer between the central metallic island and the leads is controlled by resonant tunneling through single phosphorus dopants in the barriers. Top gates above the barriers are used to control the resonance conditions. Applying radio frequency signals to the gates, non-adiabatic quantized electron pumping is achieved. A simple deterministic model is presented and confirmed by comparing measurements with simulations.
Graphene Cardboard: from Ripples to Tunable Metamaterial
2014
Recently graphene was introduced with tunable ripple texturing, a nanofabric enabled by graphene's remarkable elastic properties. However, one can further envision sandwiching the ripples, thus constructing composite nanomaterial, graphene cardboard. Here the basic mechanical properties of such structures are investigated computationally. It turns out that graphene cardboard is highly tunable material, for its elastic figures of merit vary orders of magnitude, with Poisson ratio tunable from 10 to -0.5 as one example. These trends set a foundation to guide the design and usage of metamaterials made of rippled van der Waals solids.
Microcavity Light Emitting Diodes Based on GaN membranes Grown by Molecular Beam Epitaxy on Silicon
2003
Resonant-cavity InGaN/GaN quantum well light emitting diodes have been fabricated. Nitride layers were grown by molecular beam epitaxy on Si (111). We fabricated the structures using a combination of Si substrate etching, GaN etching and dielectric (Ta2O5/SiO2) mirror deposition. The electroluminescence spectra show that the emission within the distributed Bragg reflector stop band is enhanced in the membrane microcavity. The cavity modes are broadened by some cavity length non-uniformity that is introduced when the GaN is back etched to adjust the cavity length. This process does not need any transfer on an intermediate host substrate and is fully compatible with large area semiconductor p…
Polymer-metal waveguides characterization by Fourier plane leakage radiation microscopy
2007
International audience; The guiding properties of polymer waveguides on a thin gold film are investigated in the optical regime. The details of propagation in the waveguides are studied simultaneously in the object and Fourier planes, providing direct measurement of both the real and imaginary parts of the effective index of the guided mode. A fair agreement between theoretical analysis provided by the differential method and experimental leakage radiation microscopy data is shown. All these tools bring valuable information for designing and understanding such devices. (C) 2007 American Institute of Physics.